Arthur Holm has added an interactive setup display to its dynamic product range

“Our role is to make sure that all our systems are able to communicate, to install, and to service as seamlessly as possible, without causing a headache for the system integrator or end user” says Henrik Holm, the company''s CEO.

Advantages:

• Step up the control of the devices

• Obtain feedback

• Straight forward installation

• Save time on installation

• Cost effective support

All ARTHUR HOLM Dynamic products are equipped with remote control through RS422, using the AHnet open protocol over CAT-5 cable with integrated loop through (up to 30 units in a single daisy-chain control line), addressing and termination and with additional control by means of the cover plate buttons and a general purpose interface (Optical Isolated Contact Closure). From now on, all Dynamic1, Dynamic1Twin, Dynamic1H, Dynamic2, DynamicX2, and Dynamic3 are supplied with this new interactive setup display.

A LCD display has been added to all these products, allowing a very easy address setup, showing the commands sent to the unit, and making the interaction with third part control systems much easier. A secondary menu allows factory service, permitting to vary parameters of movement and safety protections. It also makes factory support much easier, without the need to have Internet in the room.