NEW: roof waterproofing membrane by IKO

Composed of a non-woven reinforced polyester reinforcing mat which is coated and impregnated with SBS modified bitumen to a nominal thickness of 3

0 mm (118 mils). A poly film is bonded to each side which disappears during the heat-welding process. Used as the base ply in a two-ply system. This product will satisfy the requirements of CGSB-37.56-M and ASTM D6164.

More information

Details

IKO

Keywords

Waterproofing membranes

Roofing barriers

Associated Trend items

NEW: synthetic roofing barrier by IKO

IKO Stormtite® synthetic underlayment is engineered to be used under asphalt shingles. And it has qualified as an IKO’s PRO4 Roofing Component. It is a cost-effective alternative to traditional #15 asphalt saturated felt, and is covered by a limited 15-year material warranty¹.

Here’s why it rocks. Stronger than felt. Stormtite® is more resistant to tearing and shredding when installers walk on it. Plus it’s coated top and bottom with tough polyolefin for superior weather-resistance with a slip-resistant surface. More flexible, even in cold weather. Stormtite® is easy to install around vents, dormers, skylights and other typical r...

More information

NEW: roll waterproofing membrane by IKO

This product is comprised of high-strength non-woven reinforced polyester which is coated and permeated with SBS modified bitumen to a nominal thickness of 4

0 mm (158 mils). The surface is covered with colored ceramic mineral granules to provide UV protection, while the underside is sanded to allow for mopping to heat-susceptible substrates and to prevent sticking in the roll. This sheet can be applied as the protective cap for conventional BUR membranes or modifed bitumen membranes.

More information

NEW: roll waterproofing membrane by IKO

A non-woven reinforced polyester reinforcing mat which is impregnated with SBS modified bitumen to a thickness of approximately 2

5 mm (98 mils). This sheet is protected on the top by a thin layer of poly-film (which disappears upon heat welding of the cap sheet), and on the bottom by sand, which allows for mopping to heat-sensitive substrates and prevents sticking in the roll

More information

Compare

Remove all

Compare up to 10 products