IKO company News and Trends items
5 mm (98 mils). This sheet is protected on the top by a thin layer of poly-film (which disappears upon heat welding of the cap sheet), and on the bottom by sand, which allows for mopping to heat-sensitive substrates and prevents sticking in the roll
5 mm (98 mils), This sheet is covered on both sides with sand to allow for mopping to heat-sensitive substrates and to prevent sticking in the roll. MP-180-SS is an enduring, non-slip base sheet which may be used in SBS layered membrane construction
0 mm (158 mils). The surface is covered with colored ceramic mineral granules to provide UV protection, while the underside is sanded to allow for mopping to heat-susceptible substrates and to prevent sticking in the roll. This sheet can be applied as the protective cap for conventional BUR membranes or modifed bitumen membranes.
Here’s why it rocks. Stronger than felt. Stormtite® is more resistant to tearing and shredding when installers walk on it. Plus it’s coated top and bottom with tough polyolefin for superior weather-resistance with a slip-resistant surface. More flexible, even in cold weather. Stormtite® is easy to install around vents, dormers, skylights and other typical r...
The mat is fully permeated with asphalt then heavily coated with our select polymer blend of SBS. Both surfaces are covered with a thin poly-film. The top film will melt during the application of the heat welded cap sheet while the bottom film dissolves during heat welding to the substrate. Torchflex HD-FF-Base can be used as the “lay-flat” base sheet in a layered membra...
2 mm (87 mils). A thin poly-film covers both surfaces. Upon application, the top-film will melt with the heat-welded cap sheet while the bottom film dissolves during heat-welding to the substrate. Product can be used as a base sheet with a Torchflex or Armourplast Cap Sheet. Product meets the requirements of CGSB 37.56M and ASTM D6163 for Type I, Grade S materials.
0 mm (118 mils). A poly film is bonded to each side which disappears during the heat-welding process. Used as the base ply in a two-ply system. This product will satisfy the requirements of CGSB-37.56-M and ASTM D6164.