NEW: roll waterproofing membrane by IKO

A non-woven reinforced polyester reinforcing mat which is impregnated with SBS modified bitumen to a thickness of approximately 2

5 mm (98 mils). This sheet is protected on the top by a thin layer of poly-film (which disappears upon heat welding of the cap sheet), and on the bottom by sand, which allows for mopping to heat-sensitive substrates and prevents sticking in the roll

More information

Details

IKO

Keywords

Waterproofing membranes

Roofing barriers

Associated Trend items

NEW: synthetic roofing barrier by IKO

IKO Stormtite® synthetic underlayment is engineered to be used under asphalt shingles. And it has qualified as an IKO’s PRO4 Roofing Component. It is a cost-effective alternative to traditional #15 asphalt saturated felt, and is covered by a limited 15-year material warranty¹.

Here’s why it rocks. Stronger than felt. Stormtite® is more resistant to tearing and shredding when installers walk on it. Plus it’s coated top and bottom with tough polyolefin for superior weather-resistance with a slip-resistant surface. More flexible, even in cold weather. Stormtite® is easy to install around vents, dormers, skylights and other typical r...

More information

NEW: roll waterproofing membrane by IKO

This product is comprised of high-strength non-woven reinforced polyester which is coated and permeated with SBS modified bitumen to a nominal thickness of 4

0 mm (158 mils). The surface is covered with colored ceramic mineral granules to provide UV protection, while the underside is sanded to allow for mopping to heat-susceptible substrates and to prevent sticking in the roll. This sheet can be applied as the protective cap for conventional BUR membranes or modifed bitumen membranes.

More information

NEW: roll waterproofing membrane by IKO

Torchflex HD-FF-Base is constructed using a mat of durable non-woven composite polyester mat which has been strengthened with a glass fiber scrim in both machine and cross directions

The mat is fully permeated with asphalt then heavily coated with our select polymer blend of SBS. Both surfaces are covered with a thin poly-film. The top film will melt during the application of the heat welded cap sheet while the bottom film dissolves during heat welding to the substrate. Torchflex HD-FF-Base can be used as the “lay-flat” base sheet in a layered membra...

More information

Compare

Remove all

Compare up to 10 products