PRIME UP SUPPORT

the adjustable support measuring just 10 mm

The creation of raised flooring is characterised by a long design and surface adjustment process. Even when installing on apparently level ground, the height adjustment of the individual supports is mainly carried out by hand, with millimetric accuracy, so that the final surface is perfectly level.

In cases where the height of the raised floor is slightly greater than the installation surface, the height adjustment of the individual supports becomes a matter of crucial importance, where 5 mm more or less can determine the planarity of the flooring and ensure or compromise a good aesthetic result.

Until now, the creation of very low raised floors was limited to the use of fixed-height supports; products limited to a few tens of millimetres thick, but without the possibility to adjust the height and often used in combination with improvised shims on site.

Impertek has always offered a wide range of fixed-height supports, with heights ranging from 5 to 19 mm, and an even more complete series of height-adjustable supports, to cover heights even above one metre. But now the range also includes a new product: Prime Up.

Prime Up is the height-adjustable support, measuring just 10 mm that, thanks to the adjustment mechanism and the combination of 2 extensions, can reach 25 mm in height, obtaining a total excursion of 15 mm.

Prime up consists of a base with a 150 mm diameter, similar to that of the Mart series, featuring a tab fitted with the adjustment mechanism head. By holding the base and turning the tab, the height of the support can be changed from 10 to 15 mm.

The top of the head is fitted with a micro-head, which can be selected among those in the extensive Impertek range for Mart series supports, with specially designed wings for wooden decking flooring, stone tiles and ceramic flooring. Each micro-head is equipped with a coupling to ensure constant adjustment even with part of the flooring already laid.

Also, below the support base, up to two extensions measuring 5mm each can be added, thus increasing the height up to a total of 25 mm. In conjunction with the extensions, it is possible to use EasyFlat, the Impertek CP slope correctors, which can correct slopes up to 10%.